Fixing a hot water heater

7 Tips to Prevent Water Heater Repairs

Spread the love

There’s nothing more frustrating than finding – usually in the midst of showering – that the water heater is no more working.

Occasionally it is discovered if you turn on the tap and only find cold water and other times it can be discovered due to an unpleasant odour. Either way, coping with a shortage of hot water is not much fun!

Fixing a hot water heater
Source : thespruce.com

But much more discouraging than the absence of hot water is knowing that replacing the water heater is very likely to be costly – if it’s the whole tank, or simply having repair work done.

Consequently, it is important to understand some basic steps to take to keep water hear repairs in a minimum. Let’s get started:

Preventing Water Heater Repairs

  1. Be confident that your water heater temperature is not put any higher than 120 degrees Fahrenheit. Not only will having it higher mean that your utility bill will probably be more expensive. But making it work harder means that there are more wear and tear on the various pieces.
  2. At least twice a year, assess the pressure relief valve to be sure it is not corroded. Catching leaks or corrosion early means less chance of future problems.
  3. Program a maintenance visit using a plumber at least once per year to make sure all the parts and bits are working properly
  4. Check to see that there is a lot of ventilation – especially if you have a gas heater! If the vents are not properly working your home can be ruined by toxic fumes.
  5. Twice per year, take care to drain the water heater to remove any sediment. If sediment is allowed to build it up may bring about a range of problems. You can drain the tank by first putting a 5-gallon bucket below the drain valve, then turning the valve counter-clockwise to release a few gallons of water into the bucket. Then close the valve and then proceed as usual.
  6. Test the pressure and temperature valve by lifting the lever up part way and then allow it to snap back into place. You should notice a gurgling sound that suggests that there was some water discharged to the drain pan. If you do not hear anything, then it is time to replace the valve.
  7. If you have a gas water heater, then take some time at least once per quarter to ensure the pilot light is lit, and also to remove any soot build up.

These hints are only of use if you apply them Thus, don ‘t wait till the current water heater has to be repaired to execute them – start today to acquire the maximum lifespan potential from your home water heater. Still, have questions, talk to a local plumber today.

Visit New Page : THE WAY TO IDENTIFY ASBESTOS INSULATION

Leave a Reply

Your email address will not be published. Required fields are marked *